Tips for Handling Issues with Water Heaters in Brandon MS

April, 2014 by Alma Abell

One of the most vital systems in a home can be Water Heaters in Brandon MS. This system can be helpful in keeping the home a person lives in clean, healthy and germ free. In addition, heated water is important for cleaning dishes, laundry and people as well. Without heated water, cleaning would be more difficult and it would not be done as thoroughly as it should be. For this reason, it is important for a homeowner to make sure their water heater is in good operating condition and have it repaired when it is not working properly.

Many times the most common issue a water heater will have is not supply heated water. This can happen for a variety of reasons. It may be the electricity or gas to the unit has been shut off by mistake and it simply needs to be switched back on. However, sometimes the issue may be inside the unit due to a damaged component, which is stopping the unit from heating or staying heated. When this type of issue occurs, it is important for the homeowner to inspect the unit or call a plumber to handle the job.

Most times checking the pilot, pilot control valve and thermocouples will enable a professional or someone with experience to detect if there are any issues present, which are causing the elements to not work correctly. If they are faulty, these elements can generally be easily replaced and the unit will begin to work again.

If Water Heaters in Brandon MS do not show any signs of faulty parts, the problem may be too much sediment is lining the inside of the water tank. When this happens, it can prevent the transfer of heat from the tank to the water. This can be checked by draining a portion of water from the unit in to a bucket. A homeowner or plumber can then look for signs of sediment present in the water. If they find evidence of sediment, the tank should be flushed.

A water heater can be flushed by attaching a hose to the drain valve at the bottom of the unit, turning the water on in the unit and letting it flow out the hose until it is clear again. Doing this will force the sediment from the tank and allow the water to be heated again.

Related Posts


Share This